Radar body Sensor waterproof led wall light

Tips:
How to install Wall Light ?
Step 1,The installation of the wall lamp should mark the position of the expansion screw on the wall according to the hole on the wall lamp hanging plate. Use an electric drill to drill holes on the marked points on the wall. Pay attention to understand the wiring layout first, do not drill into the wires, but also pay attention to the depth of the drilled holes.
Step 2,After drilling the holes, you can start to install the expansion screws. First, insert the expansion screws into the drilled holes, and then use a hammer or other objects to drive the expansion screws into the wall until all are submerged in the wall. Pass the wood screw through the hole of the wall lamp hanging plate, and then fix it on the expansion screw. Note that the fixing on both sides should be carried out alternately, so as to avoid the offset of the wood screw.
Step 3,Connect the hanging plate and the ceiling plate with screws, and then tighten the bald screws to fix the ceiling plate. Finally, disconnect the indoor power supply, then connect the wall lamp's wire and power cord, and install the wall lamp.
Remarks:The installation height of outdoor wall lights is generally slightly higher than the eye level, about 1.8 meters. The height of the wall lamp is generally 1440~1850mm from the working surface, and 2240~2650mm from the ground. But the distance between the wall lamp in the bedroom and the ground can be closer, about 1400mm~1700mm. The distance between the wall lamp and the wall is closer, generally 95mm~400mm.