Bridge lighting and used

The new modern bridge landscape lighting design must consider the integration of more modern elements and the overall integration with the existing urban layout. Show the characteristics of The Times, innovation, high technology and so on. The design scheme takes energy saving, environmental protection, safety and project cost into full consideration.

According to the structural characteristics of the bridge is divided into three levels, using different expression methods for landscape lighting design. The first layer for the bridge deck upper main tower and cable lighting, through the light transmission, using the surface light source method will be the most prominent sign of the main tower light, using the line light source method will be the cable light into luminous lines; The lighting of the profile of the side arc of the second layer arch bridge uses flood lighting to show the complete and three-dimensional effect of the bridge.

The use of bridge luminaires
Due to the large number of lamps used in bridge lighting engineering, the following matters should be paid attention to in bridge lighting engineering design:
1. Determine the location of lamps. As the bridge lighting project is the construction of new lamps after the bridge has been completed, the lighting project mainly aims to highlight the shape of the bridge and beautify the city night scene.
2. The placement of lighting lamps directly affects the actual effect of bridge lighting and the difficulty of maintenance management. The lamps are arranged too high on both sides of the bridge, and the effect of light radiation and setting off is not obvious. At the same time, if the lighting position is too high, the lighting is vulnerable to external damage, security risks and operation and maintenance costs increase; The installation position of lamps is too low, which increases the difficulty of construction operation and future maintenance, and the distant view effect of the bridge is poor due to the increased impact surface of lights.
3. When laying the bridge and conduit on the bridge, attention should be paid to the damage and influence of the bridge and conduit support on the existing bridge structure during the installation process. Therefore, the waste holes generated in the construction process and support installation should be sealed with epoxy mortar in time to reduce the damage to the structure.
4. The lamps and equipment of the bridge lighting project are different from the general lighting lamps and lanterns in the working environment, most of which belong to the open-air operation. In the installation process of the bridge lighting and equipment, it is necessary to fully do the anti-aging and anti-rain work of the lamps and equipment lines.
5. The bridge lighting construction is the construction work of the new lighting installation project outside the existing structure. The new content is all open installation, and some lamps are small in size, which is easy to be damaged and affected by the outside
6. Safety management of bridge lighting construction. Urban bridge lighting construction, safety management is difficult. On the one hand, the bridge as the main channel of the city, the traffic is busy, the traffic volume is large, the construction is seriously disturbed by the outside world; On the other hand, there is water flow under the bridge, and the bridge lighting is arranged on both sides of the bridge, the need for air, high work, more dangerous. Therefore, in the process of lighting construction, safety management is difficult, safety production requirements are high.
Contact Syalighting