General installation steps of spike lights

2022-12-26

When the LED Garden Light is installed, open the lamp housing, install the light source and supporting electrical appliances, lead the outgoing line from the threading hole to the bottom of the lamp pole, then connect the lamp cap with the lamp pole, pay attention to tightening the fastening screws, and then align the lawn lamp flange with the screw of the foundation embedded parts, standing vertically. Then tighten the mounting nuts after leveling with nuts or pads.

1. Embedded pipeline.
When wiring lawn lamps, a wire smaller than the distribution phase line shall be used as the grounding wire to connect the metal shell of lamps or lamp posts. If the length of the grounding wire is more than 25 meters, a repeated grounding shall be made at the end. A 4mmx40mm galvanized flat iron with a length of 25 meters can be buried for repeated grounding, and five grounding electrodes can be made. The grounding electrode is a 5x50 galvanized angle steel with a length of 5 meters, which is vertically driven into the ground. The grounding electrode and the galvanized flat iron are welded at a distance from each other.

2022-12-26-01

2. Foundation pouring.

The foundation pouring of lawn lamps is generally done by the construction workers in the early stage, but it should be noted that the embedded pipelines need to be led out to avoid the failure of normal use in the later stage.

2022-12-26-03

3. Install the lawn lamp.
Open the package of the lawn lamp and check its integrity. Assemble the lamp according to the product manual. The method of going through the hall is to open the lamp housing, install the light source and supporting electrical appliances, lead out the outgoing line from the threading hole to the bottom of the lamp pole, then connect the lamp cap with the lamp pole, pay attention to tightening the fastening screws, and then align the lawn lamp flange with the screw of the foundation embedded parts, standing vertically. Then tighten the mounting nuts after leveling with nuts or pads.

2022-12-26-04

2022-12-26-05

4. Power cord wiring.
The connection of lawn lamps should be carried out by professional electricians, and safe and reliable grounding must be done at the same time to avoid leaving potential risk factors for later use.

Pay attention to the spacing when installing LED Garden Lawn Lamp

The lamp is 0.5m high, and the distance between 23W energy-saving lamps is required to be about 11m, so that the lighting effect is optimal and a lot of costs can be saved. The distance between garden lamps is about 25 meters. The lawn lamps are installed more in places around rockeries and pavilions depending on the specific situation and requirements. The installation of lawn lamps is a problem that needs to be considered in many aspects. Users must pay attention to the specific installation. They should select lamps with good quality, especially in damp places. They should also select lamps with certain preventive effects. After the lawn lamp is installed, the installation effect is good, and the safety effect can be achieved, so that the use effect can be better displayed.

2022-12-26-06